Dana 30
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation.
This article needs additional citations for verification. (September 2011) |
It has been manufactured as a beam axle and independent suspension axle with several versions.
General specifications
- Ring Gear measures 7.12 inches (181 mm)
- OEM Inner axle shaft spline count: 27
- GAWR up to 2770 lbs.
Dana 30 solid axles
Dana 23
The Dana Spicer 23 is an axle the Dana 30 is loosely based, with improvements throughout time. This axle was only made for the rear of vehicles. Full floating and semi floating variations were produced.
Dana 25
The Dana Spicer 25 was based on the Dana 23 and was made only as a front axle for four-wheel drive vehicles. This was the company's first front drive axle.
Dana 27
The Dana Spicer 27 unit phased out Dana 23 and Dana 25 units in the 1960s
Independent front suspension Dana 30 axle
Jeep Liberty 4x4 models use the Dana 30 in the form of independent suspension in the front (IFS).
The AMC Eagle front axle is also a Dana 30 IFS.
References
This article uses material from the Wikipedia English article Dana 30, which is released under the Creative Commons Attribution-ShareAlike 3.0 license ("CC BY-SA 3.0"); additional terms may apply (view authors). Content is available under CC BY-SA 4.0 unless otherwise noted. Images, videos and audio are available under their respective licenses.
®Wikipedia is a registered trademark of the Wiki Foundation, Inc. Wiki English (DUHOCTRUNGQUOC.VN) is an independent company and has no affiliation with Wiki Foundation.